Kawasaki Ninja Service Manual: Idle Speed Control Valve Actuator (Service Code 1C)

KIBS Hydraulic Unit Communication Error (Service Code 1b, KIBS Equipped Models)

KIBS Hydraulic Unit Communication Line Inspection When the data (for status of KIBS hydraulic unit) is not sent from the KIBS hydraulic unit to the meter unit and ECU, the service code 1b is displa ...

Idle Speed Control Valve Actuator Removal

NOTICE Never drop the idle speed control valve actuator especially on a hard surface. Such a shock to the actuator can damage it. Remove: Throttle Body Assy (see Throttle Body Assy Removal in ...

Other materials:

Vehicle-down Sensor Installation
Be sure to install the rubber dampers [A] and collars [B] on the bracket. The UP mark [A] of the sensor should face upward. WARNINGIncorrect installation of the vehicle-down sensor could cause sudden loss of engine power. The rider could lose balance during certain ...

Crankshaft Sensor Peak Voltage Inspection
NOTE Be sure the battery is fully charged. Using the peak voltage adapter [A] is more reliable way to determine the condition of the crankshaft sensor than crankshaft sensor internal resistance measurements. Disconnect the crankshaft sensor lead connector (see Crankshaft Sensor ...

Oil Level Inspection
If the oil has just been changed, start the engine and run it for severalminutes at idle speed. This fills the oil filter with oil. Stop the engine, then wait several minutes until the oil settles. NOTICE Racing the engine before the oil reaches every part can cause engine seizure. ...