Kawasaki Ninja Service Manual: Rear Sprocket Installation

Rear Sprocket Removal

Remove the rear wheel (see Rear Wheel Removal in the Wheels/Tires chapter). NOTICE Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc. Place bl ...

Coupling Installation

Apply high-temperature grease to the following. Coupling Grease Seal Lips [A] Coupling Internal Surface [B] Ball Bearing [C] Install: Collar [A] Coupling ...

Other materials:

Fuel Tank and Cap Inspection
Visually inspect the gasket [A] on the tank cap for any damage. Replace the gasket if it is damaged. Check to see if the water drain pipe [B] and fuel breather pipe [C] in the tank are not clogged. Check the tank cap breather also. If they are clogged, remove the tank and drain it ...

Chain Slack Inspection
Set the motorcycle up on its side stand. Rotate the rear wheel to find the position where the chain is tightest, and measure the maximum chain slack by pulling up and pushing down the chain midway between the engine sprocket and rear wheel sprocket. A. Chain Slack If the ...

Exhaust Device
This motorcycle is equipped with a exhaust device system. This system controls the valve in the exhaust pipe and produces stable engine power at low and middle engine speed. This exhaust device is controlled by the ECU, and adjustment or maintenance should be done only by a competent mechanic ...