Kawasaki Ninja Service Manual: Final Drive

Hub Bearing Inspection

Since the hub bearings are made to extremely close tolerances, the clearance can not normally be measured. NOTE Do not remove any bearings for inspection. If any bearings are removed, they will ne ...

Exploded View

HG: Apply high-temperature grease. HO: Apply heavy oil. L: Apply a non-permanent locking agent. MO: Apply molybdenum disulfide oil solution. (mixture of the engine oil and molybden ...

Other materials:

Outline
When a problem occurs with DFI system, the warning indicator light (LED) [A] and FI warning symbol [B] goes on to alert the rider. In addition, the condition of the problem is stored in the memory of the ECU. For models equipped with an immobilizer system, the warning indicator light (LED) and ...

Water Temperature Sensor Inspection
Remove the water temperature sensor (see Water Temperature Sensor Removal/Installation in the Fuel System (DFI) chapter). Suspend the sensor [A] in a container of coolant so that the temperature-sensing projection [C] is submerged. Suspend an accurate thermometer [B] with temperature ...

Fluid Level Inspection
With the brake fluid reservoirs held horizontal, the brake fluid level must be kept between the upper and lower level lines. A. Front Brake Fluid Reservoir B. Upper Level Line C. Lower Level Line A. Rear Brake Fluid Reservoir B. Upper Level Line C. Lower Level Line If th ...