Kawasaki Ninja Service Manual: Subthrottle Valve Actuator (Service Code 62)

Radiator Fan Relay Inspection

Refer to the Relay Circuit Inspection in the Electrical System chapter If the radiator fan relay is normal, check the wiring for continuity, using the wiring diagram in this section. Special ...

Subthrottle Valve Actuator Removal

NOTICE Do not remove the subthrottle valve actuator [A] since it has been adjusted and set with precision at the factory. Never drop the throttle body assy especially on a hard surface. Such a ...

Other materials:

Chassis Parts Lubrication
Before lubricating each part, clean off any rusty spots with rust remover and wipe off any grease, oil, dirt, or grime. Lubricate the points listed below with indicated lubricant. NOTE Whenever the vehicle has been operated under wet or rainy conditions, or especially after using a high ...

Intake Air Pressure Sensor #1 Removal
NOTICE Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Intake Air Pressure Sensor #1 Connector [A] Remove the intake air ...

Steering Play Inspection
Remove the lower fairings (see Lower Fairing Removal in the Frame chapter). Raise the front wheel off the ground with the jack. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 With the front wheel pointing straight ahead, alternately tap each end of the handlebar. The f ...