Kawasaki Ninja Service Manual: Swingarm

Rear Shock Absorber Scrapping

WARNINGPressurized nitrogen may explode when heated. The rear shock contains nitrogen gas. To avoid an explosion, do not incinerate the shock body without first releasing the nit ...

Swingarm Removal

Remove: Rear Wheel (see Rear Wheel Removal in the Wheels/Tires chapter) Mud Guard with Rear Brake Hose (see Mud Guard Removal in the Frame chapter) Rocker Arm (see Rocker Arm Removal) R ...

Other materials:

Wheel Bearing Damage Inspection
Raise the front wheel off the ground with the jack (see Front Wheel Removal in the Wheels/Tires chapter). Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 Turn the handlebar all the way to the right or left. Inspect the roughness of the front wheel bearing by moving [A] ...

Diode Circuit Inspection
Remove the relay box (see Relay Box Removal). Check conductivity of the following pairs of terminals (see Relay Box Internal Circuit in this section). Diode Circuit Inspection The resistance should be low in one direction and more than 10 times as much in the other direction. If any dio ...

Exhaust Butterfly Valve Actuator Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the front seat (see Front Seat Removal in the Frame chapter). Remove the screws [A] and the exhaust butterfly valve actuator temporarily with the cables installed. Disconnect the exhaust butterf ...