Kawasaki Ninja Service Manual: Wheels/Tires

Clutch

Clutch Operation Inspection Pull the clutch lever just enough to take up the free play [A]. Measure the gap between the lever and the lever holder. If the gap is too wide, the clutch may no ...

Tire Air Pressure Inspection

Remove the air valve cap. Measure the tire air pressure with an air pressure gauge [A] when the tires are cold (that is, when the motorcycle has not been ridden more than a mile during the pa ...

Other materials:

Connecting Rod Twist Inspection
With the big-end arbor [A] still on V block [C], hold the connecting rod horizontally and measure the amount that the arbor [B] varies from being paralleled with the surface plate over a 100 mm (3.94 in.) length of the arbor to determine the amount of connecting rod twist. If the conne ...

Nozzle Assy Disassembly
Remove the nozzle assy (see Nozzle Assy Removal). Pull out the secondary fuel injectors [A] from the delivery pipe assy [B]. NOTE Do not damage the insertion portions of the injectors when they are pulled out from the delivery pipe assy. NOTICE Never drop the secondary fuel injecto ...

Intake Air Pressure Sensor #2 Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Disconnect the intake air pressure sensor #2 connector and connect the measuring adapter [A] between these con ...