Kawasaki Ninja Service Manual: Radiator

Kawasaki Ninja Service Manual / Cooling System / Radiator

Mechanical Seal Inspection
Remove the impeller (see Oil Pump Removal in the Engine Lubrication System chapter). Visually inspect the mechanical seal. If any one of the parts is damaged, replace the mechanical seal as ...

Radiator and Radiator Fan Removal
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Coolant (Drain, see Coolant Change in the Periodic Maintenance chapter) Air Cleaner Housing (see A ...

Other materials:

Oxygen Sensor Heater Resistance Inspection
Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the oxygen sensor lead connector [A]. Connect a digital meter [A] to the terminals in the oxygen sensor lead connector [B]. Measure the oxygen sensor heat ...

Fuel Filter Cleaning
The fuel filter [A] is built into the fuel pump and can not be cleaned or checked. If the fuel filter is suspected of clogging or being damaged, replace it with the fuel pump as a set. Fuel Pump Circuit 1. Ignition Switch 2. Engine Stop Switch 3. Joint Connector E 4. ECU 5. Engine G ...

Radiator Cap Inspection
Remove: Radiator Cap (see Coolant Change in the Periodic Maintenance chapter) Check the condition of the bottom [A] and top [B] valve seals and valve spring [C]. If any one of them shows visible damage, replace the cap with a new one. Install the cap [A] on a cooling system pr ...