Kawasaki Ninja Service Manual: Clean Air System

Special Tools and Sealant

Compression Gauge, 20 kgf/cm²: 57001-221 Valve Spring Compressor Assembly: 57001-241 Valve Spring Compressor Adapter, 25: 57001-1019 Valve Seat Cutter, 45° - 27.5: 57001-1114 Valve ...

Air Suction Valve Removal

Remove: Air Switching Valve (see Air Switching Valve Removal) Air Suction Valve Cover Bolts [A] (Both Sides) Air Suction Valve Covers [B] (Both Sides) Remove the air suction valves ...

Other materials:

Starter Clutch Assembly
Install the one-way clutch [A] to the driven gear. Face the circlip side of the one-way clutch to inside. Install the new snap ring [B] to the one-way clutch. Install the drive gear [C] while turn it counterclockwise [D]. Apply molybdenum disulfide oil solution to the needle bearing ...

Alternator Inspection
There are three types of alternator failures: short, open (wire burned out), or loss in rotor magnetism. A short or open in one of the coil wires will result in either a low output, or no output at all. A loss in rotor magnetism, which may be caused by dropping or hitting the alternator, by leav ...

Fuel Injector Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the ECU (see ECU Removal). Do not disconnect the ECU connector Connect a digital meter [A] to the connector (gray) [B] with the needle adapter set. Special Tool - Needle Adapter Set: 57001-1457 ...