Kawasaki Ninja Service Manual: External Shift Mechanism

Gear Dog and Gear Dog Hole Damage Inspection

Visually inspect the gear dogs [A] and gear dog holes [B]. Replace any damaged gears or gears with excessively worn dogs or dog holes. ...

Shift Pedal Removal

Remove: Shift Lever Bolt [A] Front Footpeg Bracket Bolts [B] If the tie-rod [C] is to be removed from the shift pedal and the shift lever, loosen the tie-rod locknuts [D]. The front tie-ro ...

Other materials:

Swingarm Bearing, Sleeve Inspection
NOTICE Do not remove the bearings for inspection. Removal may damage them. Inspect the needle bearings [A] and ball bearing installed in the swingarm. The rollers and ball in a bearing normally wear very little, and wear is difficult to measure. Instead of measuring, visually inspec ...

Front Wheel Removal
Remove: Front Caliper Mounting Bolts [A] (Both Sides) Front Caliper [B] (Both Sides) Loosen: Front Axle Clamp Bolts [A] (Right Side) Front Axle [B] Remove the lower fairings (see Lower Fairing Removal in the Frame chapter). Raise the front wheel off the ground. ...

Camshaft Chain Tensioner Installation
Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Release the stopper [B] and push the push rod [C] into the interior of the tensioner body [D] so that the position of the push rod is 3 or 4 notches [E] as shown in the figure. Install the tensioner body so that the ...