Throttle Control System InspectionOil Pump Installation
Install the outer rotor [A] into the crankcase.
Assemble:
Oil (Water) Pump Shaft [B]
Pin [C]
Inner Rotor [D]
To prevent dropping, apply grease to the pin.
Install the inner rotor assembly into the crankcase.
Fit the slot [E] onto the projection [F].
Replace the O-ring [A ...
Meter Unit Removal/Installation
Remove the upper fairing assembly (see Upper Fairing
Assembly Removal in the Frame chapter)
Remove the bolt [A] (other than US, CA and CALmodels).
Slide back the dust cover and disconnect the meter unit
connector [B].
Remove:
Bolts [A]
Nut [B] (other than US, CA and CAL mode ...
Crankshaft Side Clearance Inspection
Insert a thickness gauge [A] between the thrust washer
[B] on the crankcase and the crank web [C] at the #3 main
journal to determine clearance.
If the clearance exceeds the service limit, replace the
thrust washers as a set and check the width of the crankshaft
#3 main journal.
Cra ...
