Kawasaki Ninja Service Manual: Main Throttle Sensor (Service Code 11)

Backups

The ECU takes the following measures to prevent engine damage when the DFI, ignition, S-KTRC or immobilizer system parts have troubles. Note: (1): D-J Method: When the engine load ...

Main Throttle Sensor Removal/Adjustment

NOTICE Do not remove or adjust the main throttle sensor [A] since it has been adjusted and set with precision at the factory. Never drop the throttle body assy especially on a hard surface. Suc ...

Other materials:

Crankcase Assembly
NOTICE The upper and lower crankcase halves are machined at the factory in the assembled state, so the crankcase halves must be replaced as a set. With a high flash-point solvent, clean off the mating surfaces of the crankcase halves and wipe dry WARNINGGasoline and low flash-poin ...

Compression Damping Force Adjuster and Rebound Damping Force Adjuster Adjustment
The compression damping force adjuster and the rebound damping force adjuster are located on top of each front fork leg. Turn the adjuster clockwise with a screwdriver to increase damping force. Turn the adjuster counterclockwise to decrease damping force. NOTICE Do not force to t ...

Air Switching Valve
Air Switching Valve Operation Test Refer to the Air Suction System Damage Inspection in the Periodic Maintenance chapter. Air Switching Valve Unit Test Remove the air switching valve (see Air Switching Valve Removal in the Engine Top End chapter). Set the hand tester [A] to the × 1 ...