Kawasaki Ninja Service Manual: Appendix

Fluid Pressure Sensor Supply Voltage Inspection (Service Code b 89)

The Fluid Pressure Sensors are built in the KIBS Hydraulic Unit. Therefore the voltage cannot be checked directly. Perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries to Rider in the B ...

Cable, Wire, and Hose Routing

1. Clamp (Hold the regulator/rectifier lead. Run the lead inside of the installation hole.) 2. Clamp (Bend down the clamp, and hold the main harness and the vacuum hose (equipped models).) ...

Other materials:

DFI Power Source
ECU Fuse Removal Refer to the 30 A Main/15 A ECU Fuse Removal in the Electrical System chapter. ECU Fuse Installation If a fuse fails during operation, inspect the DFI system to determine the cause, and then replace it with a new fuse of proper amperage. Refer to the Fuse Installation in ...

Daily Checks
Check the following items each day before you ride. The time required is minimal, and habitual performance of these checks will help ensure you a safe, reliable ride. If any irregularities are found during these checks, refer to the Maintenance and Adjustment chapter or see your dealer fo ...

Tire Removal
Remove: Wheels (see Front/Rear Wheel Removal) Valve Core (Let out the air) To maintain wheel balance, mark the valve stem position on the tire with chalk so that the tire can be reinstalled in the same position. Chalk Mark or Yellow Mark [A] Valve Stem [B] Align [C] Lu ...