Kawasaki Ninja Service Manual: Calipers

Kawasaki Ninja Service Manual / Brakes / Calipers

Brake Pedal Installation
Apply grease to the brake pedal pivot shaft [A]. Install: Washers [B] Brake Pedal [C] Apply a non-permanent locking agent to the threads of the brake pedal mounting bolt [D], and tighten ...

Front Caliper Removal
Remove: Bolt [A] Front Wheel Rotation Sensor [B] Loosen the banjo bolt [C] at the brake hose lower end, and tighten it loosely. Unscrew the caliper mounting bolts [D], and detach the ca ...

Other materials:

Lap Counter/Coolant/Intake Air Temperature Meter
This meter shows the coolant temperature, the intake air temperature or the lap number. The lap number is displayed in the stop watch mode, refer to the “Stop Watch� item in this section. A. Lap Counter/Coolant / Intake Air Temperature Meter The coolant temperature meter and inta ...

Swingarm Bearing Installation
Replace the needle bearings, ball bearing, grease seals and circlip with new ones. Install the needle bearings, ball bearing, grease seals and circlip as shown in the figure. Insert the needle bearing driver [A] into the needle bearing [B] and press the needle bearing into the housing u ...

DFI Parts Location
Main Throttle Sensor [A] Subthrottle Sensor [B] Idle Speed Control Valve Actuator [C] Subthrottle Valve Actuator [D] Intake Air Pressure Sensor #2 [E] Stick Coils #1, #2, #3, #4 [F] Air Switching Valve [G] Intake Air Pressure Sensor #1 [H] Water Temperature Sensor [A] Primary Fuel Injec ...