Kawasaki Ninja Service Manual: Clutch

Clutch Cover Assembly

Replace the needle bearings and oil seal with new ones. NOTE Install the needle bearings so that the manufacture’s mark face out. Install the needle bearings [A] and oil seal [B] pos ...

Clutch Removal

Remove: Clutch Cover (see Clutch Cover Removal) Clutch Spring Bolts [A] Clutch Springs (with Clutch Spring Holders) Clutch Spring Plate [B] Pusher [C] Remove: Friction Plates ...

Other materials:

Solenoid Valve Inspection (Service Code b 13, b 14, b 17, b 18)
The solenoid valve is built in the KIBS Hydraulic Unit [A]. Therefore the solenoid valve cannot be checked directly. Perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries to Rider in the Brakes chapter). If any of these service codes appears even if all checks are ended, replace t ...

Lower Crankcase Assembly
Install the ball bearing [A] and the oil level inspection window [B] until they are bottomed Apply soap and water solution to the oil level inspection window before installation. Install the new circlip [C]. Apply a non-permanent locking agent to the oil passage plug [D]. Tighten: ...

ECU Power Supply Inspection
Remove the upper air cleaner housing (see Air Cleaner Element Replacement in the Periodic Maintenance chapter). Visually inspect the ECU connectors. If the connector is clogged with mud or dust, blow it off with compressed air. Remove the ECU (see ECU Removal). Visually inspect the ...