Kawasaki Ninja Service Manual: Electric Starter System

Kawasaki Ninja Service Manual / Electrical System / Electric Starter System

IC Igniter Inspection
The IC igniter is built in the ECU [A]. Refer to the following items. Interlock Operation Inspection (see Interlock Operation Inspection) Ignition System Troubleshooting (see Ignition Syst ...

Starter Motor Removal
Drain the coolant (see Coolant Change in the Periodic Maintenance chapter). Remove: Thermostat (see Thermostat Removal in the Cooling System chapter) Slide out the rubber cap [A]. Re ...

Other materials:

Air Suction Valve Inspection
Remove the air suction valve (see Air Suction Valve Removal). Visually inspect the reeds [A] for cracks, folds, warps, heat damage or other damage. If there is any doubt as to the condition of the reeds, replace the air suction valve as an assembly. Check the reed contact areas [B] of ...

ABS and KIBS Indicator Lights (LED) Inspection
In this model, the ABS indicator light (LED) [A] and KIBS indicator light (LED) [B] go on or blink by the data sent from the KIBS hydraulic unit. Refer to the Meter Unit Inspection in the Electrical System chapter. ABS and KIBS Indicator Lights (LED) Function *: The mode of “Low ...

Battery Removal
Turn off the ignition switch. Remove the front seat (see Front Seat Removal in the Frame chapter). Slide the red cap [A]. Disconnect the negative (–) cable [B] and then positive (+) cable [C]. NOTICE Be sure to disconnect the negative (–) cable first. Remove the band [D] ...