Kawasaki Ninja Service Manual: Fairings

Kawasaki Ninja Service Manual / Frame / Fairings

Rear Seat Installation
Place the seat hook [A] to the slot [B] under the rear frame rear. Insert the seat latches [C] into the latch holes [D]. Push down the seat until the lock clicks. ...

Lower Fairing Removal
Remove the quick rivets [A]. Remove: Quick Rivets [A] Bolts [B] Pull up the core by the flat-head screwdriver (–), and then remove the quick rivet. Clear the hook portions o ...

Other materials:

Oxygen Sensor - not activated (Service Code 33, Equipped Models)
Oxygen Sensor Removal/Installation Refer to the Oxygen Sensor Removal/Installation (Equipped Models) in the Electrical System chapter. Oxygen Sensor Inspection Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Oxygen Sensor Lead Connector [A] Connect t ...

Rocker Arm/Tie-Rod Bearing, Sleeve Inspection
NOTICE Do not remove the bearings for inspection. Removal may damage them. Visually inspect the rocker arm, or tie-rod sleeves [A] and needle bearings [B]. The rollers in a needle bearing normally wear very little, and wear is difficult to measure. Instead of measuring, inspect the ...

Release Shaft Installation
Apply grease to the oil seal lips on the upper ridge of the clutch cover. Apply engine oil to the needle bearings in the hole of the clutch cover. Applymolybdenum disulfide grease to the pusher-holding portion [A] on the release shaft. Install the washer [B] and spring [C]. ...