Kawasaki Ninja Service Manual: Switches and Sensors

Immobilizer Amplifier Replacement

Remove the upper fairing assembly (see Upper Fairing Assembly Removal in the Frame chapter). Disconnect the connector [A]. Pull out the immobilizer amplifier [B] together with the rubber pr ...

Switch Inspection

Using a hand tester, check to see that only the connections shown in the table have continuity. Special Tool - Hand Tester: 57001-1394 For the switch housings and the ignition switch, refer t ...

Other materials:

Fuel Filter Cleaning
The fuel filter [A] is built into the fuel pump and can not be cleaned or checked. If the fuel filter is suspected of clogging or being damaged, replace it with the fuel pump as a set. Fuel Pump Circuit 1. Ignition Switch 2. Engine Stop Switch 3. Joint Connector E 4. ECU 5. Engine G ...

Bolts, Nuts and Fasteners Tightness Inspection
Check the tightness of the bolts and nuts listed here. Also, check to see that each cotter pin is in place and in good condition. NOTE For the engine fasteners, check the tightness of them when the engine is cold (at room temperature). If there are loose fasteners, retighten them to ...

Seat Cover Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], install it along the corner [B] as shown in the figure. When installing the pad [C], align the ends [D], along the corner [E], and wrap [F] the upper edge of the seat cover. Install the damper [A] ...