Kawasaki Ninja Service Manual: Suspension

Kawasaki Ninja Service Manual / Suspension

Wheel Rotation Sensor Rotor Inspection
Remove: Wheels (see Front/Rear Wheel Removal in the Wheels/Tires chapter) Brake Disc Mounting Bolts [A] Sensor Rotor [B] Front Wheel [C] Rear Wheel [D] Visually inspect the wh ...

Exploded View
AL: Tighten the two clamp bolts alternately two times to ensure even tightening torque. G: Apply grease. R: Replacement Parts G: Apply grease. L: Apply a non-permanent lock ...

Other materials:

Electrical Leads
A two-color lead is identified first by the primary color and then the stripe color. Unless instructed otherwise, electrical leads must be connected to those of the same color. Instrument Use a meter that has enough accuracy for an accurate measurement. Read the manufacture’s instructions ...

Front Brake Pad Installation
Check that the pad spring [A] is in place on the caliper. Push the caliper pistons in by hand as far as they will go. Install the brake pads [A] on the pad spring correctly. Fit the pad into the groove of the caliper as shown in the figure. Install the pad pins while pushing t ...

Bolts, Nuts and Fasteners Tightness Inspection
Check the tightness of the bolts and nuts listed here. Also, check to see that each cotter pin is in place and in good condition. NOTE For the engine fasteners, check the tightness of them when the engine is cold (at room temperature). If there are loose fasteners, retighten them to ...