Kawasaki Ninja Service Manual: Replacement Parts

Bolts, Nuts and Fasteners Tightness Inspection

Check the tightness of the bolts and nuts listed here. Also, check to see that each cotter pin is in place and in good condition. NOTE For the engine fasteners, check the tightness of them ...

Air Cleaner Element Replacement

NOTE In dusty areas, the element should be replaced more frequently than the recommended interval. WARNINGIf dirt or dust is allowed to pass through into the throttle body assy, the t ...

Other materials:

Lights and Switches Operation Inspection
First Step Set the gear position in the neutral position. Turn the ignition switch to ON. The following lights should go on according to below table. If the following light does not go on, inspect the meter unit (see Meter Unit Inspection in the Electrical System chapter). ...

Oil Pump Installation
Install the outer rotor [A] into the crankcase. Assemble: Oil (Water) Pump Shaft [B] Pin [C] Inner Rotor [D] To prevent dropping, apply grease to the pin. Install the inner rotor assembly into the crankcase. Fit the slot [E] onto the projection [F]. Replace the O-ring [A ...

Intake Air Pressure Sensor #1 Removal
NOTICE Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Intake Air Pressure Sensor #1 Connector [A] Remove the intake air ...