Kawasaki Ninja Service Manual: Wheels (Rims)

Kawasaki Ninja Service Manual / Wheels/Tires / Wheels (Rims)

Special Tools
Bearing Driver Set: 57001-1129 Jack: 57001-1238 Bearing Remover Head, 25 × 28: 57001-1346 Bearing Remover Shaft, 13: 57001-1377 Jack Attachment: 57001-1608 ...

Front Wheel Removal
Remove: Front Caliper Mounting Bolts [A] (Both Sides) Front Caliper [B] (Both Sides) Loosen: Front Axle Clamp Bolts [A] (Right Side) Front Axle [B] Remove the lower fair ...

Other materials:

Replacement Parts
Replacement parts must be KAWASAKI genuine or recommended by KAWASAKI. Gaskets, O-rings, oil seals, grease seals, circlips, cotter pins or self-locking nuts must be replaced with new ones whenever disassembled. Assembly Order In most cases assembly order is the reverse of disassembly, howe ...

Master Cylinder Inspection (Visual Inspection)
Remove the master cylinders (see Front/Rear Master Cylinder Removal). Disassemble the front and rear master cylinders (see Master Cylinder Rubber Parts Replacement in the Periodic Maintenance chapter). Check that there are no scratches, rust or pitting on the inner wall [A] of each ma ...

Ball Bearing and Needle Bearing
Do not remove pressed ball or needle unless removal is absolutely necessary. Replace with new ones whenever removed. Press bearings with the manufacturer and size marks facing out. Press the bearing into place by putting pressure on the correct bearing race as shown. Pressing the incorrect ra ...